Owners Manual

24
REACH-INS & ROLL-INS
OPERATIONS MANUAL
PAN SLIDE INSTALLATION
Pan slides should be installed in pairs, to ensure each set is
level at the same height. Before installing the slides, determine
the spacing desired between each pan that will be placed in the
cabinet. Align one of the pan slides against the vertical support
(see Figure 11A). Simultaneously insert the (2) studs on the
slide into the upper end of the slot on the vertical supports at the
desired height and the pan slide will simply drop down and lock
into place. Install another slide into opposite vertical supports,
using the same method. Check that the pair of slides are level
and at the proper height. Repeat this procedure for the remain-
ing sets of pan slides.
2. All refrigerant should be removed from the system by a
qualified technician and disposed of properly, or reclaimed.
(Intentional venting of many refrigerants into the air is harm-
ful and prohibited; violators are subject to fines). All refriger-
ant oil should be drained from the compressor and discarded
appropriately.
3. Properly dispose of the cabinet and refrigeration system
components. The majority of the metal in your unit (stainless
steel or aluminum cabinet shell and doors, steel shelving and
compressor, copper refrigerant lines, etc.) can be recycled.
Many recycling facilities will dispose of the unit free of
charge, or pay you for scrap value of the material content.
OPTIONAL ACCESSORIES
PAN SLIDE ASSEMBLIES
Pan slide assemblies are available in a variety of configurations
(see Figure 11). The unique design of the vertical supports
allow the pan slides to be mounted on 1” centers and be read-
ily removed for cleaning, without the use of tools or additional
hardware. If your new unit was ordered from the factory with
pan slides, the vertical supports will be pre-installed directly on
the outer walls of the cabinet. On 2- and 3-section cabinets, the
vertical pan supports in the middle of the cabinet are mounted to
center supports as shown (see Figure 11A). The pan slides are
wrapped up in the accessory package, inside the cabinet.
FIGURE 11: Pan Slide Assembly Configurations
LH SLIDE
SUPPORT
CENTER
VERTICAL
SUPPORT
RH SLIDE
SUPPORT
PAN
SLIDES
PAN SLIDE
INSTALLATION
PAN SLIDES MOUNTED IN 2 SECTION INTERIOR
FIGURE 11A: Pan Slide Assembly Components