User's Guide

brouillage est susceptible d'en compromettre le fonctionnement. »
This radio transmitter (2807E-FE4NA0210) has been approved by Industry Canada to operate with the
antenna types listed below with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for
use with this device.
« Le présent émetteur radio (2807E-FE4NA0210) a été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne
non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits
pour l'exploitation de l'émetteur.».
3 Device Installation and User Manual
The FE4NA0210 module is a proprietary product designed and manufactured by Continental Automotive
Systems, Inc. for integration into telematics control units manufactured by Continental Automotive
Systems, Inc.
i. The module is limited to installation ONLY in an integrated device manufactured by Continental
Automotive Systems, Inc.
ii. During manufacturing process of the integrated device, the module is soldered onto the pcb of the
integrated device.
iii. The integrated device must provide RF connectors to external antennas or RF traces to connect the
FE4NA0210 modules to antennas inside the integrated device. The typical reference design for the
RF trace layout, including pcb stack-up and trace length is described in Section 6 of this document.
iv. Automotive OEM is responsible for ensuring that the end-user has no manual instructions to
remove or install module.
v. The module is limited to installation in mobile applications, according to Part 2.1091(b).
vi. No other operation configurations are allowed.
vii. Changes or modifications to this system by other than a facility authorized by Continental could
void authorization to use this equipment.
viii. The module does not have a pre-defined antenna. Under No conditions may an antenna gain be
used that would exceed the ERP and EIRP power limit as specified in Part 22, Part 24 and Part 27.
ix. The integrator is responsible for fulfilling FCC and IC requirements for the integrated device. SAR
is related to the final product’s implementation and should be assessed based on its proximity to
human body.
If Continental chooses to re-use modular approval, then the TCU shall be clearly labeled with an external
label containing the integrated modem’s FCC ID. For example, the label can include text “Contains
device with FCC ID: LHJ-FE4NA0210 and IC: 2807E-FE4NA0210”.