Manualshelf

Installation Instructions

ManualsBrandsContinental ManualsElectronics2G, 3G, LTE cat11 module
12345678
Continental Pripriotary Confidential
4.0 VEHICLE INSTALLATION GUIDELINES
Normal operating conditions are between -40
o
C to +80
o
C.
The sheet metal cover is designed to be a heat sink. A gap between the heat sink and the
mounting surface is recommended to facilitate heat transfer out of the module. Exceptions
can be made if the module is mounted to a surface that can help facilitate heat transfer such
as a large aluminum body panel.
WARNING: When the temperature of the device is above 70oC, the metal cover will be hot.
DO NOT TOUCH.
The device does not have sealed connectors. It is designed to meet Class I water intrusion
conditions (no drip test required), so it should not be placed in area that can get wet.
Continental recommends that the automotive OEM uses the mating harness supplier’s
recommendations for the keep out zone around the connectors to ensure proper mating of
each connector.
Changes or modifications to this system by other than a facility authorized by Continental
could void authorization to use this equipment.
5.0 REGULATORY COMPLIANCE NOTES
FCC:
This device complies with Part 15, Part 22(H), Part 24(E) and Part 27 of the FCC Rules. The
device contains FCC ID LHJ-WT50NA02. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
INDUSTRY OF CANADA:
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.”
« Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le