Installation Instructions

7
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY OF CANADA:
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.”
« Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement. »
This device contains a radio transmitter with IC ID 2807E-WT50NA02 has been approved by
Industry Canada to operate with the antenna types listed below with the maximum
permissible gain indicated. Antenna types not included in this list, having a gain greater than
the maximum gain indicated for that type, are strictly prohibited for use with this device.
« Cet appareil contient un émetteur radio avec IC ID 2807E-WT50NA02 a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un
gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de
l'émetteur.».
MEXICO:
La operación de este dispositivo está sujeta a las siguientes dos condiciones:
(1) Este equipo o dispositivo no deberá ocasionar interferencias perjudiciales.
(2) Este equipo o dispositivo debe aceptar cualquier interferencia recibida, incluidas aquellas
que pudieran causar un funcionamiento no deseado.
6.0 EXTERNAL ANTENNA REQUIREMENTS FOR USE WITH HNA11_00 TCU
The HNA11_00 device is for use with external antennas ONLY.
This radio transmitter (FCC ID: LHJ-WT50NA02; IC: 2807E-WT50NA02) has been
approved by FCC and Industry Canada to operate with the antenna types listed below with
the maximum permissible gain indicated. Antenna types not included in this list, having a
gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
« Le présent émetteur radio (ID: LHJ-WT50NA02; IC: 2807E-WT50NA02) a été approuvé
par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant
un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain