Instructions / Assembly

#500 - I0500 - 0703
6
B. Gently lower the Rollers
(#10) into position so that
they are seated in the track.
Make sure that the panel
rolls freely.
C. Hold the Outside Door
Panel (#5) so that the
R o l l e r s (#10) are facing
towards you. Standing out-
side of and facing the
shower enclosure, use the
index finger of both hands
to carefully push the Inside
Door Panel (#6) back and
out of the way as you lift the
Outside Door Panel (#5)
up and over the Bottom
Track/Curb (#2) and then
slide the top rail up and into
the Header (#1). Or, if
someone is assisting you,
have him/her hold the
Inside Door Panel (#6)
back out of your way. DO
N O T let the two panels
strike one another. Set the
Rollers (#10) into the front
track of the Header (#1).
D. V E RY C A R E F U L LY s e a t
the Outside Door Panel
(#5) into the track and
make sure that it rolls
f r e e l y. Carefully let the
Inside Door Panel (#6)
ease back into position.
E. Slide both panels to one side.
STEP 10 Installing the Guide
A. Locate the Guide (#7) and #6 x 5/16″ PHFT Screw
(#13). Position the Guide (#7) on the B o t t o m
Track/Curb (#2) exactly
midway between the
Wall Jambs (#3).
B. The top edge of the
Guide (#7) fits under
the metal groove on the
front part of the Bottom
Track/ Curb (#2). Using
the hole in the Guide (#7), drill a 1/8″ hole into the
Bottom Track/Curb (#2).
C. Use a #6 x 5/16″ PHFT Screw (#13) to secure the
Guide (#7) in place.
STEP 11 Installing the Handle
A. Locate the Handle (#8) and one two-sided tape
(#15). Remove the backing from one side of the
tape and place inside the Handle (#8). Remove
the backing from the tape inside the Handle (#8).
B. Standing in the shower, with the curved part of the
handle facing into the shower, position the Handle
(#8) midway on the frame of the Inside Panel (#5)
(as measured from the bottom of the Panel), on
the edge nearest the Wall Jamb (#3) near the
shower head. Gently tap the Handle (#8) into
place.
C . Repeat these steps on the Outside Panel (#5).
Install the Handle (#8) on the Outside Panel (#5)
on the edge nearest the Wall Jamb (#3).
STEP 12 Silicone Sealing the
Enclosure
NOTE: Before siliconing the enclosure, make sure the
surface is completely free of dirt or any other
contaminants to ensure proper adhesion.
Using clear silicone, seal along the interior and
e x t e r i o r edges of the Header (#1), Wall Jambs
(#3) and Bottom Track/Curb (#2).
NOTE: Silicone sealant must cure for 24 hours before you
use your new enclosure. Silicones may vary.
Please follow curing instructions on the tube.
Inside
of shower
Position Handle
midway on Door Panel
Handle:
Curved part
faces into
shower
Install the
Guide midway
between the Wall
Jambs
Outside
Shower
C
C
D
Push
Inside
Panel
away
with
your
fingers
Outside
Shower
Inside
Shower
A
A
B
Caulk where:
• Wall Jambs and wall meet
• Bottom Track/Curb and
Wall Jambs meet
• Bottom Track/Curb and
shower sill meet
500 Install. Instruc. 7/1/03 8:24 PM Page 6