Instructions / Assembly

ManualsBrandsContractors Wardrobe ManualsAlcove Shower Doors34-1/8 in. to 36-1/8 in. x 63-1/2 in. Framed Pivot Shower Door in Bright Clear with Rain Glass

Model 6100

Illustrated Installation

Instructions

Shower Doors

DESIGNERS • MANUFACTURERS

26121 Avenue Hall • Valencia, CA 91355

(661) 257-1177 • Fax (661) 257-4907

Or visit our website at: www.cwdoor.com

Summary of content (6 pages)

PAGE 1
Model 6100 Illustrated Installation Instructions Shower Doors DESIGNERS • MANUFACTURERS 26121 Avenue Hall • Valencia, CA 91355 (661) 257-1177 • Fax (661) 257-4907 Or visit our website at: www.cwdoor.
PAGE 2
Illustrated Parts Breakdown (IPB) Drawing Model #6100 23 23 19 (For Shower Head on Left) 6 22 13 17 20 18 24 16 15 24 24 22 19 20 2 10 9 22 18 21 22 19 19 26 18 7 20 21 1 11 20 25 20 19 3 5 4 22 6 15 12 22 16 17 19 21 14 NO.
PAGE 3
In this instruction booklet we will walk you through the installation of your new shower door. (#16) 2 Spanner Washer (#17) 2 Kep Nut DO NOT REMOVE your old shower door until you check your new shower door kit for all the proper parts. Make sure that you have all the proper tools required to assemble your new shower door. Use this check list.
PAGE 4
B. Locate the Adjustable Pivot Jamb (#1), the Adjustable Pivot Jamb Brackets (#2) and six #8 x 1/2” FH SMS Screws (#24). C. Secure the Adjustable Pivot Jamb Brackets (#2) to the Adjustable Pivot Jamb (#1) with the #8 x 1/2” FH SMS Screws (#24). Tighten the bottom three screws completely. Tighten the top three screws only half way. D. E. F. G.
PAGE 5
STEP 6 Installing the Pivot Pin Assemblies A. B. Locate the Pivot Pins (#15), Spanner Washers (#16), Kep Nuts (#17) and Pivot Bushing (Top) (#13). tighten the Kep Nuts (#17) at the top and bottom of the door, maintaining the 1/8” gap. D. 13 17 16 15 Loosely assemble the two Pivot Assemblies: Pivot Pin (#15), Spanner Washer (#16) and Kep Nut (#17). 15 Place the square head of a Pivot Pin 16 (#15) into each 17 pivot slot of the Door Top and Figure 4 Bottom Rails (#6) on the door panel.
PAGE 6
the surface of the shower sill. Press the Drip Rail (#11) onto the Bottom Rail (#6). E. F. Next, use the 7/64” Drill Bit and, using the pre-drilled holes, carefully drill two holes in the Bottom Rail (#6). Using the remaining two #6 x 1/4” “B”-Point Screws (#20), secure the Drip Rail (#11) with Drip Rail Gasket (#12) to the Door Panel (See Figure 6). B. A. Locate the Handle Outside (#9), Handle Inside (with Holes) (#10) and the two #8 x 1 1/2” FH SMS Screws (#22).