Model 7800 / 8800 Reversible Top Rail Enclosure Illustrated Installation Instructions
Illustrated Parts Breakdown (IPB) Drawing Model 7800 / 8800 15 11 14 No. Qty Part # Part Description #1 #2 #3 #4 #5 #6 #7 #8 #9 #10 Wall Brackets 1” Round Tube Rail Rail Stop Rail/Fixed Panel Clamps Fixed Glass Panel Sliding Door Panel Wheel Assemblies Hollow Door Pull Floor Guide Glass-to-Wall Clamp 2 1 2 2 1 1 4 1 1 2 B3160 R2000 R1000 C1250 Glass Glass W8140 H9050 G1300 C1200 No.
NOTE: If you ordered a custom unit, your parts may be different based on what you order. Congratulations on purchasing your new Cw® unit. In this instruction booklet we will walk you through the installation of your new Tub/Shower Enclosure. NOTE: Check the following conditions of the Tub/Shower Curb prior to installation (See Figure 1).
STEP 1 #11 1 Bi-Pass Splash Guard #12 2 Setting Blocks #13 1 U-Channel #14 1 Dam Strip #15 1 Wall Polycarbonate #16 1 Allen Wrenches Removing Existing Shower Doors After determining that your newly purchased Tub/Shower Enclosure is the correct size, remove the existing Tub/Shower Enclosure and all existing parts of that door assembly. Remove all screw anchors from the wall. Clean silicone sealant or Tub/Shower caulking and any other contaminants from Tub/Shower and wall surfaces.
STEP 4 Fixed Glass Panel Installation G. Make all necessary adjustments, ensuring the 1” Round Tube Rail (#2) is level and the Fixed Glass Panel (#5) is plumb. NOTE: One of the two (2) Rail Stops (#3) and one of the Wall Brackets (#1) have already been pre-assembled on the 1” Round Tube Rail (#2). However, you will need to adjust them later during the installation process. A. First assemble the 1” Round Tube Rail (#2).
M. Place Fixed Glass Panel (#5) in the U-Channel (#13) back in the designated position. You should apply silicone to the full length of the U-Channel (#13) to fill up approximately 1/4” of the inside of the U-Channel (#13) before placing the Fixed Glass Panel (#5) into it. Then slide the Wall Brackets (#1) on each 1” Round Tube Rail (#2). B. Step into the tub/shower enclosure. Carefully lift the Sliding Door Panel (#6), and place the Wheel Assemblies (#7) onto the 1” Round Tube Rail (#2). C.
H. Install the Hollow Door Pull (#8) on the Sliding Door Panel (#6). I. Adjust the two (2) Rail Stops (#3) to prevent the Sliding Door Panel (#6) from striking the walls. Use set screws in Rail Stops (#3) to fix them on the 1” Round Rail Tube (#2). J. Remove the two-way tape from Wall Polycarbonate (#15) and attach to the wall where Sliding Door Panel (#6) makes contact. K. Install the Bi-Pass Splash Guard (#11) to back edge of Sliding Door Panel (#6). STEP 6 Use and Repair A.