Instructions / Assembly

Step 4 Installing the
Mirrored Glass Panels
A. Make sure you have a pad or blanket to protect
the Panels (#1) from scratches. Lay Panels (#1)
with backside up on the floor.
Locate one of the Steel
Wheel Assemblies (#14) on
the bottom of a Panel (#1).
With a Phillips Screwdriver,
turn the adjusting screw to the
right to lower the roller. Do this
u n t i l you have 1″ of roller
s h o w i n g . Adjust both Steel
Wheel A s s e m b l i e s (#14) on
each panel (This will avoid
s c r a t c h i n g the Bottom Tr a c k
(#3) when installing the
Panels (#1)).
B. Pick up one Panel (#1) and, with the mirror facing
you, tilt the top of the Panel (#1) back and slip the
Panel (#1) into the back runner of the To p
Channel (#2). Next, set the bottom of the Panel
(#1) into the back runner of the Bottom Track (#3).
C. For the front Panel (#1), repeat B, but place the
Panel (#1) into the front runner of the Top Channel
(#2) and front runner of the Bottom Track (#3).
Step 5 Adjusting the Panels
A. Slide the front Panel (#1) to the side closest to the
room’s entrance door (This is how the wardrobe
doors will be in position to look their best). Look at
the space between the door edge and the wall.
You want the door edge and the wall to be flush.If
you see space at the top or bottom edge of the
Panel (#1), turn the adjusting screw on top of the
Steel Wheel Assembly (#14) on the lower back of
the Panel (#1) nearest the wall. Turn the screw
left or right until the Panel (#1) aligns flush with
the wall (See Figure 4 ) .
Figure 4
B . Slide the back Panel (#1) to the opposite wall.
Adjust the alignment of this Panel (#1) by turning
the adjustment screw on the Steel Wheel A s s e m b l y
(#14) nearest the wall until the door aligns straight,
up and down, with the wall.
Step 6 Installing the Clear Plastic
Bumpers
Peel paper off the back of the clear Plastic Bumpers
(#9) and place on the edge of the panel frame 36″
up from the bottom. The Clear Plastic Bumpers (#9)
will cushion and protect the door and wall when you
close the Wardrobe Doors (See Figure 5).
Figure 5
Step 7 Installing the Mirror Handles
A. Clean mirror in the area where the Mirror Handles
(#8) will be applied. Peel paper off the back of the
Mirror Handles (#8). Position each Mirror Handle
(#8) 36″ from the bottom of the Panel (#1) and 1
1
/2″ from Side Mold (#12) on each Panel (#1) (See
Figure 5).
B. If there are three Panels (#1), place two Mirror
Handles (#8) (one on each side of the mirror) on
the center Panel (#1).
5
1
1
/2″
1
1
/2″
HANDLE HANDLE
BUMPER
BUMPER
36″
36″
Thank you for purchasing a CW
®
Wardrobe Door. This
is only one of a large line of wardrobe doors and high
quality bath enclosure products. If you like this product,
please contact Contractors Wa r d r o b e
®
for more
information about our many beautiful bath enclosures
available in a vast array of colors and finishes to suit
your designing needs.
Fantasy IV
®
/Asprey
®
- I3070-0802
Fantasy IV/Asprey - Web 3/20/03 10:59 AM Page 5