Instructions / Assembly

ManualsBrandsContractors Wardrobe ManualsDoors & WindowsAsprey 96 in. x 81 in. Mirror Satin Gold Aluminum Interior Sliding Door

Installation Instructions

Models Fantasy IV

and Asprey

DESIGNERS • MANUFACTURERS

26121 Avenue Hall • Valencia, CA 91355 • (661) 257-1177

FAX: (661) 257-4907

or visit our website at: www.cwdoor.com

Fantasy IV/Asprey - Web 3/20/03 10:58 AM Page 1

Summary of content (5 pages)

PAGE 1
Fantasy IV/Asprey - Web 3/20/03 10:58 AM Page 1 Installation Instructions Models Fantasy IV and Asprey ® ® DESIGNERS • MANUFACTURERS 26121 Avenue Hall • Valencia, CA 91355 • (661) 257-1177 FAX: (661) 257-4907 or visit our website at: www.cwdoor.
PAGE 2
Fantasy IV/Asprey - Web 3/20/03 10:58 AM Page 2 ILLUSTRATED PARTS BREAKDOWN (IPB) MODELS Fantasy IV and Asprey 6 ® ® 5 2 13 6 5 6 12 12 5 16 9 6 8 14 16 1 1 14 15 15 12 14 15 15 9 14 8 15 6 Steel Wheel Assembly 14 7 6 13 7 6 7 10,11 NO.
PAGE 3
Fantasy IV/Asprey - Web 3/20/03 10:59 AM Page 3 FLOOR CHECK LIST Congratulations on purchasing your new CW® Wardrobe Doors. Now that you have opened the package, we want you to verify that you have all the necessary hardware supplied with your doors. 1. Do you have carpet? It is highly recommended that if you have carpet and do not have a cut-out in the carpet already, you should cut the carpet in order to install the Bottom Track (#3).
PAGE 4
Fantasy IV/Asprey - Web 3/20/03 10:59 AM Page 4 INSTALLING THE DOORS Step 1 C. Removing the Existing Doors Remove existing doors, brackets, top channel and bottom track. Step 2 Find the correct offset measurement using the Offset Measuring Table on page 3 (B Measurement) for your particular installation. From the front edge of closet opening inward, measure using dimension from table and make a pencil mark on wall. Do this on both walls, i.e., right and left walls (See Figure 2).
PAGE 5
Fantasy IV/Asprey - Web Step 4 A. B. 3/20/03 10:59 AM Page 5 Installing the Mirrored Glass Panels B. Make sure you have a pad or blanket to protect the Panels (#1) from scratches. Lay Panels (#1) with backside up on the floor. Locate one of the Steel Wheel Assemblies (#14) on the bottom of a Panel (#1). With a Phillips Screwdriver, turn the adjusting screw to the right to lower the roller. Do this until you have 1″ of roller showing.