Instructions / Assembly

Thank you for purchasing a CW
®
Wardrobe Door.
This is only one of a large line of wardrobe doors and
high quality bath enclosure products. If you like this
product, please contact Contractors Wardrobe
®
for
more information about our many beautiful bath
enclosures available in a vast array of colors and
finishes to suit your designing needs.
Step 4 Installing the Mirrored
Glass Panels (Concord
™
only)
A. Make sure you have a pad or
blanket to protect the Mirrored
Glass Panels ( # 1 ) f r o m
scratches. Lay Mirrored Glass
Panels ( # 1 ) with backside up on
the floor. Locate one of the Steel
Wheel Assemblies (#13) on the
b o t t o m of a Mirrored Glass Panel
( # 1 ). With a Phillips
S c r e w d r i v e r, turn the a d j u s t i n g
screw to the right to lower the
r o l l e r. Do this until you have 1″ o f
roller showing. Adjust both Wheel A s s e m b l i e s (#13)
on each Mirrored Glass Panel ( # 1 ) (This will
avoid scratching the Bottom Track (#3) when
installing the panels).
B. Pick up one Mirrored Glass Panel ( # 1 ) and, with
the mirror facing you, tilt the top of the Mirrored
Glass Panel ( # 1 ) back and slip the Mirrored Glass
Panel ( # 1 ) into the back runner of the To p
Channel (#2). Next, set the bottom of the Mirrored
Glass Panel (#1) into the back runner of the
Bottom Track (#3).
C . For the front Mirrored Glass Panel ( # 1 ), repeat B,
but place the Mirrored Glass Panel ( # 1 ) into the
front runner of the Top Channel (#2) and front
runner of the Bottom Track (#3).
Step 5 Adjusting the Panels
(Concord
™
only)
Slide the front Mirrored Glass Panel ( # 1 ) to the
side closest to the room’s entrance door (This is
how the Wardrobe Doors will be in position to look
their best). Look at the space between the door
edge and the wall. You want the door edge and the
wall to be flush. If you see space at the top or
bottom edge of the Mirrored Glass Panel ( # 1 ), turn
the adjusting screw on top of the Steel Wheel
Assembly (#13) on the lower back of the Mirrored
Glass Panel ( # 1 ) nearest the wall. Turn the screw
left or right until the Mirrored Glass Panel ( # 1 )
aligns flush with the wall. Repeat for each Mirrored
Glass Panel ( # 1 ) .
Step 6 Installing the
Clear Plastic Bumpers
Peel paper off the back of the Clear Plastic
Bumpers (#8) and place on the edge of the Mirrored
Glass Panel (#1) frame 36″ up from the bottom.
The Clear Plastic Bumpers (#8) will cushion and
protect the door and wall when you close the
Wardrobe Doors (See Figure 5).
Figure 5
Concord
™
/ Silhouette
™
- I3045 - 0806
Bumper
5
36″
Bumper
S
S
36″
Figure 4
Concord/Silhouette Instructions 8/1/06 10:48 AM Page 5