Instructions / Assembly

STEP 6 Installing the Clear
Plastic Bumpers
Peel paper off the back of the Clear Plastic Bumpers
(#9) and place on the edge of the Mirrored Panel
(#1) frame 36″ up from the bottom. The Bumpers
(#9) will cushion and protect the door and wall when
you close the wardrobe doors (See Figure 5).
Figure 5
B. Pick up one Mirrored Panel (#1) and, with the
mirror facing you, tilt the top of the Mirrored Panel
(#1) back and slip the Mirrored Panel (#1) into the
back runner of the Top Channel (#2). Next, set the
bottom of the Mirrored Panel (#1) into the back
runner of the Bottom Track (#3).
C . For the front Mirrored Panel (#1), repeat B, but
place the Mirrored Panel (#1) into the front runner
of the Top Channel (#2) and front runner of the
Bottom Track (#3).
STEP 5 Adjusting the Panels
A. Slide the front Mirrored Panel (#1) to the side
closest to the entrance door. Look at the space
between the door edge and wall. You want the
door edge and wall to be flush. If you see space
at the top or bottom edge of the Mirrored Panel
(#1), turn the adjusting screw on top of the Steel
Wheel Assembly (#14) on the lower back of the
Mirrored Panel (#1) nearest the wall. Turn the
screw left or right until the Mirrored Panel (#1) i s
flush with the wall (See Figure 4 ) .
Figure 4
B . Slide the back Mirrored Panel (#1) to the opposite
wall. Adjust the alignment of this panel by turning
the adjustment screw on the Steel Wheel A s s e m b l y
(#14) nearest the wall until the door aligns straight,
up and down, with the wall.
BUMPER
BUMPER
36″
36″
1-1/2″ 1-1/2″
5
Style Lite
®
- 0308
MIRROR
HANDLE
MIRROR
HANDLE
Thank you for purchasing a CW
®
Wardrobe Door. This
is only one of a large line of wardrobe doors and high
quality bath enclosure products. If you like this product,
please contact Contractors Wa r d r o b e
®
for more
information about our many beautiful bath enclosures
available in a vast array of colors and finishes to suit
your designing needs.
STEP 7 Installing the Mirror Handles
A. Clean mirror in the area where the Mirror Handles
(#8) will be applied. Peel paper off the back of the
Mirror Handles (#8). Position each Mirror Handle
(#8) 36″ from the bottom of the Mirrored Panel
(#1) and 1-1/2″ from Side Mold (#12) on each
Mirrored Panel (#1) (See Figure 5).
B. If there are three Mirrored Panels (#1), place two
Mirror Handles (#8) (one on each side of the
mirror) on the center Mirrored Panel (#1).
Style Lite Instructions 3/22/08 12:52 AM Page 5