Owner manual

5 - 78

P1/4

EDIT BLOCK 0

Blk0 Val 1

->Line Spd SP

Blk0 Val 2

->NOT USED

Blk0 Val 3

->NOT USED

Blk0 Val 4

->NOT USED

Save Changes?

Press...

ENTER to Save

CLEAR to Discard

Press the Enter key to

save your changes or

press the Clear key to

discard your changes.

Edit Block / Save

Press the Menu key from any of the Edit Block screens to exit. If you have made changes in any of

the screens (pages 1-4), a dialog box will popup and give you the opportunity to either save or to

discard your changes.

NOTE: Once you have exited the Edit Block screen, if you change the value of a Control Parameter

in any other screen (that is not a block screen) and that change can create problems with that

Control Parameter when the block is put into use, then the error message “Invalid Blk” will flash

briefly in the error message bar. Generally this scenario would only happen if a math error or an

undefined operation were created in the block which houses the Control Parameter that changed.

For example, If you change the value of a scaling parameter which is also used in a block and the

affect that the change has on the block would create an overflow (e.g., a setpoint is too large in

relationship to CP-208) then the block would become unusable or an “invalid block.”