Datasheet

ZNPKL-SYM-MATCH
Black FLF mounting plate,
equipped with one matcher for
external oor sockets, serving
as multifunctional stereo audio
input. All signals are galvani-
cally isolated via a special audio
transmitter and led level-adapted
to a joint clamp output. The ba-
lanced signals XLR (+4dBu) are
transferred 1:1 to the rear side
clamp output. The unbalanced
signals (-10dBV) phono and 6,3
mm stereo jack (Combo) are
transformed 1:4 to the clamp
output through the same internal
transmitter up to an output level
of about +4dBu. The phono
inputs are switched in parallel to
the combo jack input. Hence an
output level of about +4dBu can
always be reached, irrespective
of whether there is a balanced
(+4dBu) or an unbalanced input
signal (-10dBV). The mass of
the balanced (switch position =
up) or the unbalanced (switch
position = down) source can be
connected through to the output
with the front switch. When set
in mid-position, the mass is
interrupted.
ZNPKL-SYM-SPLIT
Black FLF mounting plate,
eqipped with one splitter,
which is particularly suitable to
record existing balanced stereo
transmissions (e.g. interpreter
equipment). Galvanic isolation is
offered as well as an additional
level-adjusted unbalanced RCA
output signal. The rear balanced
signal (+4dBu) fed on the
pressure clamp is splitted into
2 outputs through the internal
transmitter (galvanic separati-
on). These connections XLRM
(+4dBu, balanced) and RCA
(-10dBV, unbalanced) are
provided to make the signal
available for further signal
processing.
Connection Input volt. Output volt.
XLR (Combo) st. + 4dBu +4dBu
Phono stereo -10dBV +4dBu
Plug stereo -10dBV +4dBu
6.3 mm (Combo)
*(Wago-Clamps; orange+, black -, white GND)
Connection Input volt. Output volt.
Wago Clamps +4dBu
orange +, black -, white GND
XLRM +4dBu
Phono (Recording-Output) -10dBV
Splitters and matchers are suitable
for oor connection boxes.
The installation depth measures
50 mm.
FLF WITH BALANCERS
flf, in- & on-wall
[ Page 13 ]