User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 78 of 199
• Check ZigBee Channel—To determine the current ZigBee channel, press Room Off, 0, 0, 3
(or Room Off, 7, 4, 7) (in that order), and then count the blinks of Room Off. The number of
blinks corresponds with the channel number.
• Reset to Factory Defaults—To reset all settings to the factory defaults (including ZigBee
channel), press Room Off, 9, 9, 9.
2.5.8.1.1 Program the System Remote Control SR-150B Programmable Buttons
On the System Remote Control SR-150, you can program six (6) buttons (Red, Green, Yellow, Blue,
*, and #) to perform programmed activities. The buttons can be programmed to execute any of the AV
device’s macros or IR codes or be programmed by room.
To program the buttons:
1. Start Composer and connect to a Director.
2. Click System Design.
3. Ensure that you have the following devices in your project:
• Controller
• System Remote Control SR-150B
• An AV device to be controlled
4. Click Connections.
5. Click the Network tab. Ensure that the Controller and the System Remote Control are both
network identified.
6. Program the programmable buttons (Red, Green, Yellow, Blue, *, or #) either based on the
selected AV device or the selected room.
Based on AV Device:
a. Click System Design.
b. Select an AV device to display the device’s Properties page.
c. On the device’s Properties page, choose Code or Macro for the button you want to program,
and then choose a code or macro from the drop-down list.