User Manual

TRAIN CHIEF® II LRCS W/ Lightweight OCU-BT – OPERATORS MANUAL
95-00-0-062, Rev 08 3-15 Control Chief Corporation
ELECTRICAL
INTERFACE
AREA
PNEUMATIC
INTERFACE
AREA
3.6.3 Dedicated Locomotive Hook-Ups
Locomotive connections to the locomotive interface panel are accomplished through the
bottom of the panel via dedicated locomotive hookups. These hookups consist of
connector sockets based on system options to facilitate ease of installation.
¾ The pneumatic connections are located on the bottom left of the panel, and include
quick connect ports for main air, locomotive brake, train brake, and bail.
¾ The rectangular connector is the general locomotive hook-up cable. The cable is a
30-conductor with a strain relief.
¾ The round connector(s) are for specific functions such as external E-Stop, strobe
status lights, and other optional features.
Refer to system prints, drawing E-XXXX-53-01 for more application specific details.
Figure 3-9: Typical Receiver / Controller Interface Connections
Refer to Figure 6-6, for typical interface diagram. Details depicted are only one example of
a typical configuration. Always refer to your system prints for details specific to your
system configuration.