User manual

IEC61131 User and Reference Manual
April 22, 2008
4
IEC 61131-3 Installation
System Requirements
The ISaGRAF Workbench requires the following minimum system configuration.
 Microsoft Windows NT4, Windows 2000 or Windows XP PRO operating systems.
NOTE: Windows 95, 98 and ME operating systems are no longer supported.
 Pentium 133MHz or better.
 Minimum 32 MB of RAM, 64MB recommended.
 Mouse or compatible pointing device.
 Hard disk with approximately 35 Mbytes of free disk space.
IEC 61131-3 Installation
The installation of the IEC 61131-3 software is completed using the following steps:
 Install ISaGRAF
 Install ISaGRAF Extensions
 Install TelePACE Firmware Loader
 Install Sentinel driver and key – Required when a hardware license key is used.
Install ISaGRAF
ISaGRAF is the IEC 61131-3 programming environment. This installation installs the
ISaGRAF Workbench.
 Insert the ISaGRAF CD in your CD-ROM drive.
 From the Windows start menu select Run.
 Enter d:\setup (where d is your CD-ROM drive) and click OK.
 Follow the on-screen instructions to complete the ISaGRAF Workbench installation.
Install ISaGRAF Extensions
The ISaGRAF Extensions provide a driver to communicate with Control Microsystems
controllers and a set of functions that are specific to the controllers. The installation of the
ISaGRAF Extensions also installs complete documentation for the Workbench and
Extensions. The following procedure installs the ISaGRAF Extensions.
 Insert the ISaGRAF CD in your CD-ROM drive.
 From the Windows start menu select Run.
 Enter d:\ISaGRAF Extensions\setup (where d is your CD-ROM drive) and click OK.
 Follow the on-screen instructions to complete the ISaGRAF Extensions installation.
Install Firmware Loader
The Firmware Loader allows you to update the firmware in your controller. The following
procedure installs the Firmware Loader.
 Insert the ISaGRAF CD in your CD-ROM drive.