Manualshelf

User manual

ManualsBrandsControl Microsystems ManualsComputer equipment5901
21222324252627282930
IEC61131 User and Reference Manual
April 22, 2008
17
Upgrading your ISaGRAF License
This section of the manual covers software and hardware license upgrades. Upgrades
include:
Increasing the IO Count
Upgrading from a hardware to software key
Upgrading the license from one version to another, e.g. 3.32 to 3.5
To perform a remote hardware license upgrade, ISaGRAF License Manager 3.5Revb is
required. Note that this version of the License Manager is more current than the one
installed with ISaGRAF 3.54.
Increasing License IO count
The following procedure is used to increase the IO count of your software or hardware
license.
1. Launch ISaGRAF License Manager 3.5Revb and select the new IO count.
2. Identify and provide your Setup Code, User Code 1 and User Code 2, to Control
Microsystems. Indicate that the Setup Code is for an IO count increase.
3. Enter the set of 4 keys provided by Control Microsystems and click on Proceed, to
update the license.
Upgrading Hardware License version
The following procedure is used to change the version of your hardware license e.g from
3.32 to 3.54.
1. Launch ISaGRAF License Manager 3.5Revb.
2. Identify and provide your Setup Code, User Code 1 and 2, to Control Microsystems.
Indicate that the code is for a hardware license upgrade.
3. Enter the sets of 4 keys provided by Control Microsystems and click on Proceed, to
update the license.
4. To upgrade the license and software version, two sets of 4 keys will be required.
ISaGRAF 3.5 Compatibility with ISaGRAF 3.32
Upgrading from ISaGRAF 3.32 to ISaGRAF 3.5
To upgrade an installed version 3.32 of ISaGRAF to version 3.5 you may install overtop of
the older version or choose to uninstall ISaGRAF first.
Installing Overtop of ISaGRAF 3.32
This is the better choice because it allows you to keep all your current projects restored.
1. Install ISaGRAF Workbench 3.5.
2. Install ISaGRAF Extensions. Even if the version of the ISaGRAF Extensions has not
changed, it must be re-installed after installing the Workbench 3.5. Any version of the
Extensions may be installed with ISaGRAF 3.5.
3. ISaGRAF will run in demo mode for 30 days. Use a Hardware license key or select
Licensing from the ISaGRAF 3.5 program group to enable a permanent software
license.