User manual

IEC61131 User and Reference Manual
April 22, 2008
540
Reference and User Manual for complete information on analog input addressing in the
SCADAPack and Micro16 controllers. Valid Modbus addresses are:
 30001 through 39998
 40001 through 49998
The Allow Duplicate Modbus Addresses checkbox determines if the Modbus I/O database
addresses assigned to the DNP data points must be unique. Check this box if you want to allow more
than one point to use the same Modbus address.
Click the OK button to accept the Short Floating Point Analog Input parameters and close the DNP
Settings dialog.
Click the Cancel button to close the dialog without saving any changes.
Click the Add button to add the current Short Floating Point Analog Input to the DNP configuration.
Click the Copy button to copy the current Short Floating Point Analog Input parameters to the next
DNP Address.
Click the Delete button to delete the current Short Floating Point Analog Input.
Click the Move Up button to move the current Short Floating Point Analog Input up one position in
the tree control branch.
Click the Move Down button to move the current Short Floating Point Analog Input down one
position in the tree control branch.
16–Bit Counter Inputs Configuration
The 16-Bit Counter Inputs property page is selected for editing by clicking 16-Bit Counter Inputs in
the tree control section of the DNP Settings window. When selected the 16-Bit Counter Inputs
property page is active.