User manual

IEC61131 User and Reference Manual
April 22, 2008
548
 For TelePACE applications select Controller >> DNP Master Status from the menu bar. See
section 0 for information on DNP Master Status diagnostics.
 For ISaGRAF applications select Tools >> Controller >> DNP Master Status from the
program window menu bar.
DNP Diagnostics require firmware version 2.20 or newer for SCADAPack controllers and firmware
version 1.50 or newer for SCADAPack 32 controllers. When an attempt is made to select the DNP
Status or DNP Master Status command for controllers with firmware that does not support the
commands an error message is displayed. An example of the error message is shown below.
To enable the use of DNP diagnostics you will need to upgrade the firmware in the controller to the
newer version.
DNP Status
When the DNP Status command is selected the DNP Status dialog is displayed. This dialog shows
the run-time DNP diagnostics and current data values for the local DNP points.
The DNP Status dialog has a number of selectable tabs and opens with the Overview tab selected.
The following tabs are displayed.
 Overview
 Binary In (binary inputs information)
 Binary Out (binary outputs information)
 AIN-16 (16-bit analog inputs information)
 AIN-32 (32-bit analog inputs information)
 AIN-Float (short float analog inputs information)
 AOUT-16 (16-bit analog outputs information)
 AOUT-32 (32-bit analog outputs information)
 AOUT-Float (short float analog outputs information)
 Counter-16 (16-bit counter inputs information)
 Counter-32 (32-bit counter inputs information)
Clicking on any tab opens the tab and displays the selected information.