User guide

Unidrive SP Short Form Guide 67
Issue Number: 2 www.controltechniques.com
Safety
Information
Product
Information
Mechanical
Installation
Electrical
Installation
Getting Started Basic parameters
Running the
motor
SMARTCARD
Advanced
parameters
Diagnostics
UL Listing
Information
Figure 8-1 Installation of the SMARTCARD
The SMARTCARD is located at the top of the module under the drive display (if
installed) on the left-hand side.
Size 0: Ensure the SMARTCARD is inserted with the contacts facing the left-hand side
of the drive.
Size 1 to 6: Ensure the SMARTCARD is inserted with the contacts facing the right-hand
side of the drive.
Easy saving and reading
The SMARTCARD has 999 individual data block locations. Each individual location from
1 to 499 can be used to store data until the capacity of the SMARTCARD is used. The
drive can support SMARTCARDs with a capacity of between 4kB and 512kB.
The data block locations of the SMARTCARD are arranged to have the following usage:
Figure 8-2 Basic SMARTCARD operation
Installing the SMARTCARD SMARTCARD installed
P
a
r
a
m
e
t
e
r
-
P
r
0
.
3
0
r
E
A
d
+
A
u
t
o
+
P
r
o
g
+
b
o
o
t
+
Pr 0.30 = rEAd + Pr 0.30 = Prog +
Pr 0.30 = Auto +
Pr 0.30 = boot +
Auto
Save
Boot
Auto Save
Drive reads all
parameters from
the SMARTCARD
Drive automatically
writes to the
SMARTCARD
when a parameter
save is performed
Programs all drive
parameters to the
SMARTCARD
Drive boots from the
SMARTCARD on
power up and
automatically writes
to the SMARTCARD
when a parameter
save is performed
NOTE
Overwrites any
data already in
data block 1