User guide

Unidrive M700 Getting Started Guide 33
Issue Number: 5
Safety information Product information
Mechanical
installation
Electrical installation
Getting started
Basic parameters Running the motor
NV Media Card
Operation
Further information
5.5 Advanced menus
The advanced menus consist of groups or parameters appropriate to a specific function or feature of
the drive. Menus 0 to 41 can be viewed on the SI-Keypad.
Table 5-2 Advanced menu descriptions
* Only applicable to Unidrive M700.
** Only displayed when the option modules are installed.
Menu Description
0 Commonly used basic set-up parameters for quick / easy programming
1 Frequency / speed reference
2Ramps
3 Frequency slaving, speed feedback and speed control
4 Torque and current control
5 Motor control
6 Sequencer and clock
7 Analog I/O
8 Digital I/O
9 Programmable logic, motorized pot, binary sum, timers and scope
10 Status and trips
11 Drive set-up and identification, serial communications
12 Threshold detectors and variable selectors
13 Standard motion control
14 User PID controller
15 Option module slot 1 set-up menu
16 Option module slot 2 set-up menu
17 Option module slot 3 set-up menu
18 General option module application menu 1
19 General option module application menu 2
20 General option module application menu 3
21 Second motor parameters
22 Menu 0 set-up
23 Not allocated
24 Ethernet module (slot 4) set-up menu*
25 Option module slot 1 application parameters
26 Option module slot 2 application parameters
27 Option module slot 3 application parameters
28 Option module slot 4 application parameters
29 Reserved menu
30 Onboard user programming application menu
31-41 Advanced motion controller setup parameters
Slot 1 Slot 1 option menus**
Slot 2 Slot 2 option menus**
Slot 3 Slot 3 option menus**
Slot 4 Ethernet menus*