User's Guide
Table Of Contents
- Important Information
- Introduction to Home Theater Controller
- Install the System
- Configure the System
- Use Home Theater Controller
- Warranty and Regulatory Compliance Information
8
This section included the following:
` Front View
` Back View
` Specifications
Front View
1. IR window — For capturing third-party IR codes from hand-held
devices (such as remote controls).
2. Data LED — Red LED light indicates data is received.
3. Link LED — Red LED light indicates Home Theater Controller has
been identified in a Control4 Composer project.
4. Power LED — Red LED light indicates AC power is present. This
LED will turn on approximately 30 seconds after the power is
applied to the device.
5. Identification/Reset Button — For identifying this device to the
system during initial setup. Also, serves as the device reset button
when pressed for 10 seconds or more.
2
3
4
5
1