User's Guide

22
Table 2-4.
Configure RS-232 (Standard Serial Cable) for
Configurable Port
Add IR Receiver Capabilities to Remote Locations
To add a remote infrared (IR) receiver to your Media
Controller:
1. Place your IR receiver “In” end at the remote location
needed.
2. Discreetly run the wires from the remote location to
the back of the Media Controller.
3. Connect the IR receiver wires (generally Power,
Signal, and Ground) to one of the Media Controller IR
In connectors (a Plugable Terminal Block connector).
Refer to the IR receiver’s documentation to
determine wiring needed and see “Use the Plugable
Terminal Blocks” on page 20.
Function DB9 Pin Phoenix
Connector
Transmit 2 TX (1)
Receive 3 RX (3)
Ground 5 GND (9)