User Manual

ManualsBrandsControl4 ManualsLinear LightControl4 C4-LA-WD-16 Warm Dimming Linear Light

™

Connecting the tape light to the Two-Wire Heavy-

Duty Connector (power feed)

1 Ensure polarity of the conductors on the connected piece of tape

light and the polarity of the wires align.

2 Peel a small portion of the protective backing from the tape light

on the end to be connected, then insert cut tape light end into the

Two-Wire Heavy-Duty Connector.

3 Close the connector onto the tape light. Using pliers, apply

pressure on each side of the connector, not just in the middle.

Ensure the teeth cut through the tape light and the connector

closes completely.

Connection diagram

Two-wire tape lights may be controlled by many methods

such as a dimmer or switch, a wired multi-channel system, or a

wireless Zigbee power supply.

The diagram below illustrates a dimmer control scheme. For

other control methods, refer to their respective install guides.

NOTE: A dimmer or switch control scheme cannot be

used in conjunction with a multi-channel control system.

Warranty and legal information

Find details of the product’s Limited Warranty at

snapone.com/legal

or request a paper copy from Customer Service at

866.424.4489

Find other legal resources, such as regulatory notices and patent

information, at

snapone.com/legal

+24

–

+24

–

Keypad Dimmer (shown)

Black

(Line in

/Hot)

White (Neutral)

Red (To Load)

Copper (To ground)

Green (To ground)

Yellow (Not used)

24V Adaptive Series

Power Supply

+24

–

in the United States and/or other countries. Control4 is also a registered trademark or trademark of Snap One, LLC. Other names and brands may be claimed as the property of their respective owners.

Snap One makes no claim that the information contained herein covers all installation scenarios and contingencies, or product use risks. Information within this speciﬁcation subject to change without

notice.

200-00818-A 2022-11-10MK