Lighting Design Guide

30
Control4 Wireless Configurable Keypad
Control4 Wireless Configurable Keypad
120V/277V (C4-KC120277), 240V (C4-KC240)
The Control4® Wireless Configurable Keypad is an elegant and
customizable user interface that unlocks the power of one-touch
automation.
Product features
• The keypad can be configured with two to seven buttons
using four dierent button sizes for a total of 37 possible
configurations (one button kit included). There’s no need to
worry about how many buttons will be needed on a specific
keypad before (or even after) installation. Available buttons
include:
• Single-height
• Double-height
• Triple-height
• Up/Down (single height)
• Available in a wide array of gloss and satin colors (see
Available Colors in the specifications table).
• Custom engraving is available to clearly identify each device.
• Backlit engraving available with programmable color control
for easy readability regardless of time of day or light level.
• Status and backlight LED colors can be set to reflect a device
or scene’s status or simply to complement the room’s decor.
• Ambient light sensor automatically adjusts backlight and
status LED brightness depending on the light level in the
room.
• Automatically adapts to application with or without neutral
wiring. For best performance, always use neutral wiring where
possible.
• Air gap actuator on the top of the switch disconnects power
to the device.
Included
• Configurable Keypad
• Keycap button Kit
• Wire nuts (120V/277V) or Terminal Block (240V)
Installation notes
• Follow all instructions in the installation guide.
• This device must be installed by a licensed electrician.
• Installs in a standard NEMA wall box using typical wiring
standards.
• For directly controlling a load, every button acts as an on/o
toggle by default (before programming).
• Requires an earth ground connection.
• Can be powered via line voltage or low voltage, using either
the Control4 36V Keypad Power Supply or the Control4 48V
Bus Power Supply.
• When used in a 3-way or 4-way scenario, note that load
control from the keypad will not be possible until the keypad
and the associated load control device have both been
identified to a Controller and properly configured.
• To prevent changes and delays in your custom engraving
order, plan and order any custom button engraving only after
the installation plan is finalized.
• Grounding is highly recommended for this product. Grounding
will protect the device from ESD (electrostatic discharge)
eects. Follow the wiring diagrams in the installation guide.
• WARNING! This device must be protected by a circuit breaker
(20A max).
For full installation instructions and warnings, see the Wireless
Configurable Keypad Installation Guide and the Keypad Button
Installation Guide. See Control4 training materials for best
practices on ZigBee installation.
Remember faceplates! (Not included)
Gloss: White (WH), Light Almond(LA),
Ivory(IV), Brown(BN), Black(BL)
Satin: Snow White (SW), Midnight
Black(MB), Biscuit(BI), Aluminum(AU)
Metal: Satin Nickel (SN), Stainless
Steel(SS), Venetian Bronze(VB)
1-Gang (C4-FP1-xx), 2-Gang (C4-FP2-xx),
3-Gang (C4-FP3-xx), 4-Gang (C4-FP4-
xx), 1-Gang Square (C4-SFP1-xx)