Lighting Design Guide

33
Control4 Wireless Fan Speed Controller
Control4 Wireless Fan Speed Controller
120V (C4-4SF120)
The Control4® Wireless Fan Speed Controller provides elegant,
quiet speed control of ceiling fans. Allows fan speed control to be
incorporated into a Control4 system for climate scheduling and
other automated events.
Product features
• Controls a single paddle-type ceiling fan.
• Includes four fan speed buttons (single-height) and one o
button (double-height).
• Available in a wide array of gloss and satin colors (see
Available Colors in the specifications table).
• Custom engraving is available to clearly identify each button.
• Backlit engraving available with programmable color control
for easy readability regardless of time of day or light level.
• Status and backlight LED colors can be set to reflect a device
or scene’s status or simply to complement the room’s decor.
• Ambient light sensor automatically adjusts backlight and
status LED brightness depending on the light level in the
room.
• Automatically adapts to application with or without neutral
wiring. For best performance, always use neutral wiring where
possible.
• Continuously monitors energy consumption of the connected
load.
Included
• Fan Speed Controller
• Wire nuts
• Wireless Fan Speed Controller Installation Guide
Installation notes
• Follow all instructions in the installation guide.
• This device must be installed by a licensed electrician.
• Installs in a standard NEMA wall box using typical wiring
standards
• Do not use to control bathroom/kitchen exhaust fans. Exhaust
fans use a dierent type of motor that is not compatible
with the Fan Speed Controller and may cause damage to the
fan and the Fan Speed Controller. The Fan Speed Controller
should only be used to control a single paddle-type ceiling
fan.
• Requires an earth ground connection and a neutral
connection.
• If the ceiling fan also contains a light fixture, a separate
dimmer or switch will be required to control the light. There
must be two load wires going to the fan—one for the fan and
one for the light.
• When used in conjunction with an Auxiliary Keypad
(C4-KA-xx), the wire connecting the Auxiliary Keypad to this
device must not exceed 150 feet (45 meters) at 120VAC and
100 feet (30 meters) at 277VAC.
• To prevent changes and delays in your custom engraving
order, plan and order any custom button engraving only after
the installation plan is finalized.
• Full fan control is available from the device before being
identified into a project.
• Grounding is highly recommended for this product. Grounding
will protect the device from ESD (electrostatic discharge)
eects. Follow the wiring diagrams in the installation guide.
• WARNING! This device must be protected by a circuit breaker
(20A max).
For full installation instructions and warnings, see the Wireless
Fan Speed Controller Installation Guide. See Control4 training
materials for best practices on ZigBee installation.
Remember faceplates! (Not included)
Gloss: White (WH), Light Almond(LA),
Ivory(IV), Brown(BN), Black(BL)
Satin: Snow White (SW), Midnight
Black(MB), Biscuit(BI), Aluminum(AU)
Metal: Satin Nickel (SN), Stainless
Steel(SS), Venetian Bronze(VB)
1-Gang (C4-FP1-xx), 2-Gang (C4-FP2-xx),
3-Gang (C4-FP3-xx), 4-Gang (C4-FP4-
xx), 1-Gang Square (C4-SFP1-xx)