Lighting Design Guide

36
Control4 Wireless 0-10V Dimmer
Control4 Wireless 0-10V Dimmer
120V/277V (C4-TV120277), 240V (C4-TV240)
The Control4® Wireless 0-10V Dimmer provides elegant, in-
wall control of 4-wire 0-10V dimmable fluorescent ballasts and
LEDs. Features the same sleek profile and customizable button
backlighting and LEDs of other Control4® wireless lighting
products.
Product features
• Can sink or source 100mA for control of up to 50 ballasts or
LED drivers.
• Built-in relay provides separate on/o control of line voltage
when required.
• Protection circuitry helps prevent device damage from short
circuits and excessive loads.
• Available in a wide array of gloss and satin colors (see
Available Colors in the specifications table).
• Custom engraving is available to clearly identify which light
each dimmer controls.
• Backlit engraving provides easy readability regardless of time
of day or light level.
• Status and backlight LED colors can be set to reflect a device
or scene status or simply to complement the room’s decor.
• Ambient light sensor automatically adjusts backlight and
status LED brightness, depending on the light level in the
room.
• Minimum and maximum dimming levels can be set to account
for dierent load types or simply to control energy usage.
• Automatically adapts to application with or without neutral
wiring. For best performance, always use neutral wiring where
possible.
• Continuously monitors energy consumption of the connected
load.
• Air gap actuator on the top of the switch disconnects power
to the device.
Included
• Wireless 0-10V DImmer
• Wire nuts (120V/277V) or Terminal Block (240V)
• 0-10V Dimmer Installation Guide
Installation notes
• Follow all instructions in the installation guide.
• This device must be installed by a licensed electrician.
• Installs in a standard NEMA wall box using typical wiring
standards.
• When used in conjunction with an Auxiliary Keypad
(C4-KA-xx), the wire connecting the Auxiliary Keypad to this
device must not exceed 150 feet (45 meters) at 120VAC and
100 feet (30 meters) at 277VAC.
• Requires an earth ground connection and a neutral
connection.
• Full load control is available from the device before being
identified into a project.
• To prevent changes and delays in your custom engraving
order, plan and order any custom button engraving only after
the installation plan is finalized.
• Grounding is highly recommended for this product. Grounding
will protect the device from ESD (electrostatic discharge)
eects. Follow the wiring diagrams in the installation guide.
• WARNING! This device must be protected by a circuit breaker
(20A max).
For full installation instructions and warnings, see the 0-10V
Dimmer Installation Guide. See Control4 training materials for
best practices on ZigBee installation.
Remember faceplates! (Not included)
Gloss: White (WH), Light Almond(LA),
Ivory(IV), Brown(BN), Black(BL)
Satin: Snow White (SW), Midnight
Black(MB), Biscuit(BI), Aluminum(AU)
Metal: Satin Nickel (SN), Stainless
Steel(SS), Venetian Bronze(VB)
1-Gang (C4-FP1-xx), 2-Gang (C4-FP2-xx),
3-Gang (C4-FP3-xx), 4-Gang (C4-FP4-
xx), 1-Gang Square (C4-SFP1-xx)