Lighting Design Guide
Table Of Contents
- Legal notices
- Introduction
- A complete control solution
- Comprehensive control options
- Enhanced user interface customization
- Integration simplicity
- Best-in-class dealer tools and support
- Wireless Lighting components
- Panelized Lighting components
- System design types
- Specifying a system
- Control4 Wireless Adaptive Phase Dimmer
- Control4 Wireless Keypad Dimmer
- Control4 Forward Phase Dimmer
- Control4 Wireless Switch
- Control4 Wireless Configurable Keypad
- Control4 Wireless Fan Speed Controller
- Control4 Wireless 0-10V Dimmer
- Control4 Auxiliary Keypad
- Control4 Wireless Outlet Dimmer and Switch
- Third-party products
- Control4 5-Slot and 2-Slot Panels
- Control4 8-Channel 0-10V Dimmer
- Control4 8-Channel Dimmer
- Control4 8-Channel Relay
- Control4 8-Port Ethernet Switch
- Control4 Bus Ethernet Gateway
- Control4 Bus Power Supply (48V)
- Control4 Decora Wired Keypad
- Control4 Square Wired Keypad
- Control4 Terminal Blocks
- Control4 4-Channel Bus Dry Contact Input Module
- Lighting project checklist
- Wireless Lighting application
- Panelized Lighting application
60
Control4 8-Port Ethernet Switch
Control4 8-Port Ethernet Switch
(C4-DIN-8ESW-E)
The Control4® 8-Port Ethernet Switch is a standard 8-port 10/100
switch that allows a single Ethernet CAT5e cable to be pulled
into a lighting panel, and then distributed to up to seven other
Control4 Panelized Lighting devices including Dimmer, Relay, and
Bus Ethernet Bridge Modules within the panel.
Product features
• 110V to 277V operation.
• Link/Activity LEDs indicate system link status and
communication activity.
• Power LED for power status.
• Reset button for rebooting the Ethernet switch without
removing power.
• Line input for power.
Included
• 8-Port Ethernet Switch
• 8-Port Ethernet Switch Installation Guide
• 8-Port Ethernet Switch Wiring Guide
Installation notes
• In the US and Canada, modules must be installed in a Control4
2-Slot or 5-Slot panel to meet regulatory requirements.
Outside of the US and Canada, modules may be installed in
either a Control4 panel, an o-the-shelf DIN rail panel, or a
custom DIN rail enclosure per local regulatory requirements.
• If using a Control4 panel, install the Terminal Block for
the 8-Port Ethernet Switch (C4-DIN-TB-PO) following the
instructions in the Terminal Block Installation Guide and in
the location defined by the Composer Pro Panel Reports. The
Terminal Block should be installed in the upper half of the
specified Terminal Block slot area. Terminal block installation
should be done prior to rough-in so that the electrician can
terminate wires during the rough-in.
• Module should be installed in a climate-controlled area.
• Module should be installed where some noise is acceptable, as
the module makes clicking noises during operation.
For full installation instructions and warnings, see the 8-Port
Ethernet Switch Installation Guide and 8-Port Ethernet Switch
Wiring Guide.