Lighting Design Guide
Table Of Contents
- Legal notices
- Introduction
- A complete control solution
- Comprehensive control options
- Enhanced user interface customization
- Integration simplicity
- Best-in-class dealer tools and support
- Wireless Lighting components
- Panelized Lighting components
- System design types
- Specifying a system
- Control4 Wireless Adaptive Phase Dimmer
- Control4 Wireless Keypad Dimmer
- Control4 Forward Phase Dimmer
- Control4 Wireless Switch
- Control4 Wireless Configurable Keypad
- Control4 Wireless Fan Speed Controller
- Control4 Wireless 0-10V Dimmer
- Control4 Auxiliary Keypad
- Control4 Wireless Outlet Dimmer and Switch
- Third-party products
- Control4 5-Slot and 2-Slot Panels
- Control4 8-Channel 0-10V Dimmer
- Control4 8-Channel Dimmer
- Control4 8-Channel Relay
- Control4 8-Port Ethernet Switch
- Control4 Bus Ethernet Gateway
- Control4 Bus Power Supply (48V)
- Control4 Decora Wired Keypad
- Control4 Square Wired Keypad
- Control4 Terminal Blocks
- Control4 4-Channel Bus Dry Contact Input Module
- Lighting project checklist
- Wireless Lighting application
- Panelized Lighting application
63
Control4 Bus Ethernet Gateway
Control4 Bus Ethernet Gateway
(C4-DIN-BEG)
The Control4® Bus Ethernet Gateway is the connection point for
all wired keypads and other devices on the Control4 Panelized
Lighting RS-485 bus.
Product features
• 110V to 277V operation.
• IP controlled.
• Converts RS-485 communication to Ethernet.
• Connection point for wired keypads and other devices on the
RS-485 bus.
• Compatible with the 48V bus power supply.
• Communicates with up to 80 Wired Keypads.
• Enables fallback operation to allow wired keypads to activate
basic lighting control, even if the main Control4 controller or
the IP router is oine.
See the Keypad Bus Wiring Recommendations document for
details on maximum number of devices per gateway.
Included
• Bus Ethernet Gateway
• Pluggable Terminal Blocks (2)
• Bus Ethernet Gateway Installation Guide
Installation notes
• May be installed in either a Control4 panel, an o-the-shelf
DIN rail panel, or a custom DIN rail enclosure per local
regulatory requirements. In a Control4 Panel, the Gateway
occupies ½ slot.
• Gateway receives power from the Bus Power Supply.
• Gateway should be installed in a climate-controlled area.
For full installation instructions and warnings, see the Bus
Ethernet Gateway Installation Guide. For bus wiring details, refer
to the Keypad Bus Wiring Guide.