Lighting Design Guide

81
Lighting project checklist
Project Rough-In
Rough-in:
 Team: Electrician, Architect,
Interior & Lighting Designer
 Electrician performs rough-in of
wiring, panelized cabinets & per agreed upon architecture
 Design topology agreed to by
C4 dealer
 Installation conforms to
C4 Reference Guide for Electricians, local and national codes
 Dealer performs low-
voltage rough-in wiring for wired keypads
Input Criteria:
 C4 dealer completes initial
system design in Control4 Composer and provides panel, module, & load reports to electrician
Key Deliverables:
 C4 dealer provides panelized
cabinets & terminal blocks to electrician for installation
 C4 dealer orders load control
modules and/or devices
Installation:
 Team: Electrician
Who does this? Installation of modules or individual distributed load control devices and keypads in each room as agreed upon by roles Electrician installs:
 AUX override
switch(es) per plan
 Initializes panelized lighting
modules with on-device configuration
 Installs all luminaries and
bulbs into each load. All loads should function, but not necessarily dim
C4 dealer installs:
 Low-voltage wired or
wireless keypads
Input Criteria:
 Quality Control (QC) of
installation
Key Deliverables:
 Basic Lighting control
is functional
 C4 dealer provides modules
and/or devices
System programming: C4 dealer installs according to the reference design:
 HC based controller  C4 approved router  C4 approved switch
C4 dealer will:
 P
rogram and configure the
lighting system
 Identify devices into
the system including load modules/devices and keypads
 Create standard lighting
scenes based upon final approval
 Adjust parameters of
lighting controls including: cold start, preset levels, max level
 Verify proper dimming
mode on each load: FWD/REV
 Verify proper dimming
of all loads
Input Criteria:
 All lighting loads are connected
and operational
 Electrician should temporarily
label all loads
Key Deliverables:
 A fully functional lighting system
Implementation review:
 Team (min): Architect, Lighting
Designer, Electrician
 Review luminary and bulb
selection and lighting scenes in each room
 Review use of keypads and
recommend keycap assignment (custom engraving for each keypad)
Input Criteria:
 Lighting system is fully
functional and programmed
 Luminaries and bulbs are
installed per design
Key Deliverables:
 Team members agree this
meets objectives of the project and client review can be scheduled
Final implementation:
 Team (min): Client, General
Contractor or other decision makers
 Final walk thru of lighting
solution by load, by room
Input Criteria:
 Client approval of load/keypad
color and finish for keycaps and faceplates
 Receipt of keycaps from C4
Key Deliverables:
 Final approval of lighting
solution including: load/keypad color/finish, lighting scenes, lighting control
 Completed Lighting solutions
binder including:
 Keypad programming report  System user manuals
 Accounting f
or:
 Prompt, detailed of all costs  Variances between
initial estimate
 Customer change orders
Device Install Programming Review with Team Client Walk-thru
6
6
8
8
7
7
9
9
5
5
Rough-In
Device Install Review
System Program
Client Walk-thru