Instruction manual

WARNING! The opener should not be installed
where the door opens over a public footpath
or roadway.
Step 5 - Assemble the Internal Gear
Insert the two forks into the ring gear (Fig. 09).
Secure with M6x45 hex serration head screw and
washer.
Step 6 - Mounting the Opener
If the internal gear does not rotate freely switch the
opener to manual by pulling the disengagement
handle down (there will be a click), so that the ring
gear can be rotated by hand.
Slide the opener over the door axle and into the drum
of the door (Fig. 10).
Ensure the internal gear is pushed in as far as possible
(without interfering with the door curtain) and that
one of the door drum’s wheel spokes is completely
between the opener’s drive forks.
Re-attach the door bracket using your reference
marks as a guide and tighten the bolts. Ensure that
the slots in the mounting bracket of the opener align
with the slots in the door bracket, otherwise the door
bracket may have to be relocated (Fig. 11).
If the bracket cannot be relocated, the opener
may be fi tted onto the axle using the opener’s
saddle and U-bolt as follows:
Using your reference marks as a guide, sit
the opener on the door mounting bracket
and secure with the opener’s U-bolt and
saddle and tighten fi rmly.
Adjust the door position (if necessary)
on the brackets so that the door feeds
smoothly into the guides. Make sure that
the centre of the door doesn’t hit the lintel
and that the curtain is not pushed forward
hard into the guide.
Remove the support and safety ropes (Fig. 11).
IMPORTANT NOTE - If the manual release
handle is more than 1.8 metres from fl oor level
when the opener is installed, extend the handle
to a height less than 1.8 metres.
Connect the power cord to a suitable power point, but
DO NOT SWITCH ON. Secure the power cord away
from any moving object (e.g. the door) with the cable
clip supplied.
With the opener still disengaged, pull the door up and
down to make sure it runs freely
a.
b.
a.
b.
c.
d.
»
i.
ii.
e.
f.
g.
Installation
Fig.09
Fig.10
Fig.11
M6 x 45 Hex Screw
Washer 6.4 x 20 x 1.6
Extension Fork
Pull manual release
handle if gear does
not rotate freely
Untie rope
Remove prop
Re-fi t bracket
Tighten U-bolt
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
11Controll-A-Door
®
Diamond PD - Power Drive Instruction Manual