Instruction manual

Coding Transmitters
Step 8.1 - Storing the Transmitter Code
The opener can only operated from remote control
transmitters that have been programmed into its memory.
Up to fourteen (14) codes can be stored in the memory.
Ensure that the battery is inserted in the transmitter.
Press the CODE SET button and release. The CODE
SET LED will illuminate to indicate the opener is in
Code Learn mode. If a valid code is not stored within
15 seconds the opener will exit Code Learn (Fig. 13).
Press the transmitter button (one of four) that you want
to control the door. The CODE SET LED will flash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second then go out.
The transmitter button is now coded - press to test.
Step 8.2 - Setting the Transmitter to Operate the
Courtesy Light Independently of the Door
Although the courtesy light comes on with each operation of
the opener, it may also be controlled by a transmitter without
operating the door.
Press the CODE SET button twice - The CODE SET LED
and courtesy light will both illuminate (Fig. 14).
Press a transmitter button not already coded into the
receiver - the CODE SET LED will begin to flash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second then go out.
The transmitter button is now coded - press to test.
Step 8.3 - Setting the Transmitter to Operate
Vacation Mode
The opener can be programmed into a “Vacation Mode”
where the opener will not respond to any transmitter except
one preprogrammed unit.
Press CODE SET button three times. The CODE SET
LED will illuminate and the courtesy light will flash
slowly (Fig. 15).
Press a transmitter button not already coded into the
receiver - the CODE SET LED will begin to flash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go out,
and the courtesy light will also switch off. This indicates
the code has been stored.
To activate Vacation Mode, close the garage door and
press the coded button for 5 seconds. The CODE SET
LED will illuminate and stay on.
To exit Vacation Mode press the transmitter button
momentarily until the CODE SET LED turns off.
a.
b.
c.
d.
e.
a.
b.
c.
d.
a.
b.
c.
d.
e.
Fig.13
Press CODE SET
button once
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the door
Fig.14
button twice
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the courtesy light
Fig.15
button three times
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the Vacation Mode
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
13Controll-A-Door
®
Diamond PD - Power Drive Instruction Manual
Press CODE SET
Press CODE SET