Instruction manual

ManualsBrandsControll-A-Door ManualsGarage Door OpenerP Diamond

Coding Transmitters

Step 8.4 - Setting the Transmitter to Operate the

Auxiliary Output

It is possible to operate other devices (e.g. alarm systems)

using one of the spare buttons of a multi-channel transmitter

coded into the Auxiliary Output feature.

Press CODE SET button four times. The CODE SET LED

will illuminate and the courtesy light will flash quickly

(Fig. 16).

Press a transmitter button not already coded into the

receiver - the CODE SET LED will begin to flash.

Press the same transmitter button again. The CODE

SET LED will illuminate for one second and then go out.

Step 8.5 - Setting the Transmitter to Operate Pet

(Pedestrian) Mode

The opener can be programmed into a “Pet Mode” where the

door opens partially to allow pets to enter/exit the garage:

Press the CODE SET button five times, the CODE SET

LED will illuminate and the courtesy light will flash

quickly (twice per second) to indicate learning mode for

Pet Mode is active (Fig. 17).

Choose a transmitter button not already coded into the

receiver. Press this button and the CODE SET LED will

begin to flash.

Press the same transmitter button again. The CODE

SET LED will illuminate for one second and then go out,

and the courtesy light will also switch off. This indicates

the code has been stored. This indicates the code has

been stored (Fig. 17).

Step 8.6 - To Erase Programmed Codes

If the CODE SET button is pressed and held for 6 seconds the

CODE SET LED will blink rapidly for one second to indicate

that all programmed codes have been erased. (Fig. 18)

Step 8.7 - Installation of the optional Wall Mounted

Transmitter

Mount the transmitter in a convenient location, yet out

of reach of children and at least 1.5m off the ground

(Fig. 19).

Make sure the door is visible from this location.

To set the transmitter codes refer to Step 8.1.

button four times

Select one of the

four buttons (not

programmed yet ) you

wish to use to control

the auxiliary output

Fig.16

Fig.19

Fig.17

button five times

Select one of the

four buttons (not

programmed yet ) you

wish to use to control

pet mode

Fig.18

Controll-A-Door

Diamond PD - Power Drive Instruction Manual14

Press CODE SET