Instruction manual

Diamond PD Power Drive : Instruction Manual

19Controll-A-Door

Diamond PD - Power Drive Instruction Manual

How To Use Your Opener

For maximum efficiency of your opener, your garage door

must be in good operating condition.

The door should be serviced annually by a Authorised

Dealer (refer to Warranty conditions on page 27).

WARNING! Activate the opener only when

the door is in full view, free of obstructions

and with the opener properly adjusted. No one

should enter or leave the garage while the

door is in motion. Do not allow children to

play near the door.

DANGER! This opener is a mains voltage plug

in domestic appliance and there are no user

serviceable parts inside this opener.

Transmitter

To operate the opener, press the programmed

transmitter button until your door begins to move

(usually 2 seconds). Make sure you can see the door

when you use the transmitter.

If you are in a vehicle you should aim the transmitter

through your windscreen (Fig. 28).

Check that the door is fully closed before you drive

away.

If you press the transmitter whilst the door is moving

the door will stop. The next press of the transmitter will

move the door in the opposite direction.

The transmitter may also be programmed to operate the

following features (see pages 13, 14 for full details):

to turn the courtesy light on and off without operating

the door,

to activate the Auxiliary Output,

to put the door into “Pet Mode” where it opens partially

to allow pet access to the garage, and/or

to put the garage door opener into “Vacation Mode”

where it will not respond to any transmitters.

NOTE: Additional transmitters may be purchased at any

time.

•

Fig.28