Instruction manual

Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
21Controll-A-Door
®
Diamond PD - Power Drive Instruction Manual
How To Use Your Opener
Safety Infra-Red Beam Option
A Safety Infra-Red Beam Kit (Part No 062153) may
be fitted to this opener.
• When this option is fitted, the operation of
this device is such that if an object (i.e. car,
child, etc.) blocks the Infra-Red beam, then
the garage door opener will not close the door
automatically.
• If the Safety Infra-Red Beam is fitted but not
operating correctly, then the door once opened
automatically, will not close automatically. The
door may be closed by reverting to manual
operation – see Manual Operation. Refer to
the Diagnostic Codes section of this Instruction
Manual.
Auto Close Option
To have the Auto Close option you must also have
a Safety Infra-Red Beam (Part No 062153) fitted
and functioning. To enable the Auto close function
remove the light diffuser from the opener and remove
the AUTO-CLS jumper near the right hand side LED
light module.
When this option is selected the garage door opener
will attempt to close the door automatically 30
seconds after opening.
If the Infra-Red Beam is interrupted whilst the door
is closing (e.g. by a person walking through the
doorway), the door will reverse to the fully open
position.
If the door does not close automatically, you may
close the door using the Manual Operation.
Remote Control Transmitter Battery
When necessary, remove the cover and replace
the battery with the same type. Dispose of the old
batteries properly.
Courtesy Light
The Courtesy Light will illuminate for approximately
4 ½ minutes each time the door is operated
automatically.
Spare buttons of multi channel remote control
transmitters (Smart Code or Dip Switch Code) or an
entry keypad can be programmed to turn the light on
and off by remote control.
Auxiliary Output
This function allows the opener to operate other devices
such as external lights, or an alarm system.
To use this function, a spare button of a multi channel
remote control transmitter (Smart Code or Dip Switch
Code) or an entry keypad, must be programmed to
operate the Auxiliary Output feature.
Vacation Mode
The radio receiver of the garage door opener can be
turned off using a remote control transmitter to activate
the Vacation Mode facility. Whilst in vacation mode the
opener will not respond to any remote control transmitter.
To activate the Vacation Mode facility, with the garage
door in the closed position, press the coded remote
control transmitter for 5 seconds. The Code Set LED
will illuminate to indicate that the opener is in “Vacation
Mode”.
To exit Vacation Mode press the same transmitter button
that was used to activate Vacation Mode until the Code
Set LED turns off.
You may program one “Smart Code”, one “Dip Switch
Code” and one “Keypad Code” to operate this feature.
It is recommended that a “Smart Code” remote control
transmitter be used as the wall button – program only one
button to control “Vacation Mode”. This will reduce the
possibility of accidental activation of this feature.
Pet Mode
A remote control transmitter can be programmed to open
the door partially (approximately 200mm) to allow pet
access to the garage.
To activate Pet Mode press the transmitter button that
has been programmed for Pet Mode - the door will open
partially. Pressing the button again will return the door to
the closed position.
Door Status Indicator (CLS OUT)
This garage door opener has a Door Status Indicator when
the garage door is fully closed. For example, this can be
wired into home automation systems.
NOTE: If the power fails, CLS OUT not indicate the true
status of the door and can only be restored once power is
returned and a close cycle has been performed.