Instruction manual

Thank you for choosing a B&D automatic garage door
opener. This automatic garage door opener has been
designed and developed in Australia by B&D Doors.
The technically advanced construction of this B&D opener
ensures you enjoy the following benefits:
Warranty
Five (5) year/10,000 cycles full parts and labour warranty
on motor, electronics and mechanical components of
the opener when installed by an authorized B&D Dealer
(conditions such as having the garage door serviced
annually also apply).
Tri-Tran Frequency Hopping Technology
Every time a transmitter is used, it simultaneously sends a
signal over three different frequencies, reducing the chance
of interference from other radio frequency sources.
Code Hopping Technology
Every time a transmitter is used a new security code is
generated from over 4.29 billion possible combinations.
Multi-Channel Transmitter
Multi-channel transmitters allow you to operate other
devices such as an adjoining garage door or automated
gate from the same handy unit.
Soft Start/Soft Stop
The opener eases into and out of each cycle for smooth
and quiet operation, and also to reduce wear on the door
and opener.
Warranty Expired Indicator
When the opener reaches the number of cycles covered
by warranty, the courtesy light will flash 10 times after
each cycle, for the next 20 cycles, to indicate this. This
can be reset by pressing the LIMIT SET button while
the courtesy light is flashing.
Safety Reversing System
Automatic safety reverse ensures personal protection from
death or serious injury if trapped under a door while closing.
Safety reverse force can be adjusted for environmental
conditions, for example windy areas, etc.
LED Courtesy Light
Taking advantage of the latest advances in Light Emitting
Diode (LED) technology, the opener features two light
modules consisting of ten LEDs each, which produces a
brilliant white light to illuminate the garage.
The LED courtesy light automatically switches on for
approximately 4 1/2 minutes (time programmable) when
operating the door. This can also be programmed to turn
on and off from a remote control transmitter.
Manual Release
Emergency manual release handle for manual
operation of the door in the event of a power failure.
Memory Retention
In case of a power failure the opener does not lose the
transmitter codes or limits settings.
Self Locking
No need to manually lock your garage door, as the
opener ‘positively’ locks the door when closed.
Periodic Maintenance Indicator
The service LED will illuminate to indicate that periodic
maintenance is required. Contact your dealer/installer
for service.
Service Fault Indicator
Flashing LED’s on the control panel easily identify
operational problems or service requirements.
Dynamic Door Profiling
Automatically compensates for changes in door
operating characteristics.
Auto-Close
Auto closing option can be programmed to close
the door approximately 30 seconds after the door
has opened. NOTE: Safety Infra-Red Beams must
be installed for this option to function.
External Antenna
An external antenna can be connected - for sites
where radio reception is a problem.
Vacation Mode
A transmitter can be programmer to disable the garage
door opener radio receiver. This is ideal if the door is to
be left idle for prolonged periods.
Pet Mode
A transmitter can be programmed to open the door
partially to allow pets access to the garage. The door
opening height is adjustable via a handheld programmer.
Door Status
(CLS Out) Door Closed Output indicates when the door
is in the closed position.
Auxiliary Output
You can program a spare button of you remote control
transmitter to operate this output to control items that
can be switched using a momentary close.
Battery Back Up
Optional battery back up or solar power is available.
About Your B&D Opener
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
5Controll-A-Door
®
Diamond PD - Power Drive Instruction Manual