Instruction manual

Installation
Fig.03
Fig.04
Fig.05
Fig.06
Step 1 - Preparation
Check the door’s operation:
The door must travel smoothly and be easy
to operate by hand.
Operating force on the bottom rail should be
approximately 70N (7kgs) force.
Adjust any tight or twisted guides/tracks
Clean the guides if there is any oil or wax
present using a suitable white spirit. The only
lubricant suitable for use on door guides is
silicon spray. DO NOT use WD-40, RP-7,
petroleum grease, or similar.
Install the locking bar covers if there are locking bar
holes in the guides. (Fig.03)
IMPORTANT NOTE - Do not lock your door
with the locking bars after installing the
opener. Remove or disable the lock using wire
or cable ties. Security is not affected as the
opener has an inbuilt locking facility.
Affi x the warning labels supplied with this opener in a
prominent place where they are clearly visible.
Choose the side where the opener will be installed
ensuring there is suffi cient sideroom.
Step 2 - Fit the Weight Bar
The weight bar must be fi tted to the bottom-centre for
proper operation of the opener.
If the door has a handle:
Remove the door handle
Fit the weight bar and refi t the handle using the new
fasteners provided (Fig.04).
If the door does not have a handle:
Locate the centre of the door at the bottom rail
(Fig.05).
Place the weight bar at this point (there is a centreline
marked on the weight bar) and mark the two positions
where the fasteners will go
Drill the two 4.5mm holes in the door and fi t the weight
bar using the new fasteners provided. (Fig.06).
Check that the door is still balanced and smooth to operate.
If it is not then the door may require servicing (refer to door
manufacturer’s instructions).
WARNING! The door and its springs are under
signifi cant tension. Adjustments should only
be carried out by experienced persons, as this
function can be dangerous if not performed
under strict safety procedures.
a.
i.
ii.
iii.
iv.
b.
c.
d.
a.
b.
a.
b.
c.
Diamond PD Power Drive : Instruction Manual
© Copyright January 2008 B&D Doors
9Controll-A-Door
®
Diamond PD - Power Drive Instruction Manual