Instruction manual

Parameters

Door status indicators

Door opener state OPEN LED (green) CLOSE LED (red) Beeper

Open On

Close On

Opening Flashing

Closing Flashing

Door travel stopped Flashing Flashing

Door obstructed when opening Flashing

Door obstructed when closing Flashing Beeps while door is

moving

Opener overloaded Alternating ﬂashes Alternating ﬂashes

Door in open position with Auto-

Close mode selected

One second ﬂashes

Mains power interrupted Rapid ﬂashes

Button Function

OPERATE Opens/stops/closes the door

CODE SET Codes a transmitter button for operate function

FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting

FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting

FORCE MARGIN SET (then) LIMIT SET Reloads the factory set default obstruction force margin setting

LIMIT SET (for 6 seconds) Clears the door limits set positions. Limits then need to be reset

LIMIT SET (the power on) and hold

until all LEDs are off

Deletes control parameters excluding transmitter storage memory

CODE SET press and hold until DOOR

CODE LED starts ﬂashing

Deletes all transmitter storage memory

LIMIT SET & CODE SET (the power on)

and hold until all LEDs are off

Deletes all control parameters and transmitter storage memory

Diamond PD Power Drive : Instruction Manual

29Controll-A-Door

Diamond Instruction Manual