Instruction manual

Please take care when testing the Safety

Obstruction Force. Excessive force may

cause SERIOUS PERSONAL INJURY and/or

PROPERTY DAMAGE can result from failure

to follow this warning.

Step 16.1 - Testing Close Cycle

Press the OPERATE button to open the door (Fig. 28).

Place a piece of timber approximately 40mm high on

the ﬂoor directly under the door (Fig. 29).

Press the OPERATE button to close door. The door

should strike the object and start to re-open.

Step 16.2 - Testing Open Cycle

Press the OPERATE button to close the door (Fig. 28).

Press again to open the door. When the door reaches

the half open point, grab the bottom rail of the door

ﬁrmly and the door should stop.

If the door does not reverse readily when closing, or

stop when opening, the force may be excessive and

need adjusting, refer to STEP 16.4 on page 18.

IMPORTANT WARNING:

If the door is closing

and is unable to re-open when obstructed,

discontinue use. Do not use a door with faulty

obstruction sensing. Repair fault and re-test

before using.

Safety Obstruction Force Test

Wood (40mm high)

Fig. 29

Fig. 28

Diamond PD Power Drive : Instruction Manual

17Controll-A-Door

P Instruction Manual