Instruction manual

8. Re-attach the door bracket using your reference marks as a guide and tighten the bolts. Ensure that the slots in

the mounting bracket of the opener align with the slots in the door bracket - the door bracket may have to be

relocated.

Note: If the bracket cannot be relocated, the opener may be ﬁtted onto the axle as follows:

• For Series 1 style doors - you will need to use two Series 1 style, 5/16” U bolts and saddles (one set supplied) to

attach the operator to the axle, or

• For Series 2 style doors - you will need to use the Series 2 style, 3/8” U bolt and cast saddle (not supplied) to

attach the operator to the axle.

9. Using your reference marks as a guide:

• For Series 1 style doors - ﬁt the new U bolt and saddle with the 2 nuts supplied and tighten ﬁrmly, or

• For Series 2 style doors - reuse the existing bolt and saddle arrangement. Note: the Series 2 style cast saddle

will need to have 1mm ground off both sides to ﬁt into the operator mounting bracket.

10. Adjust the door position (if necessary) on the brackets so that the door feeds smoothly into the guides. Make

sure that the center of the door doesn’t hit the lintel and that the curtain is not pushed forward hard into the guide.

11. Remove the support and safety ropes.

If the manual release is more than 1.8 metres from ﬂoor level when the opener is

installed, extend the manual release handle to a height less than 1.8 metres.

12. Connect the power cord to a suitable power point - do not switch on. Secure the cord away from any moving

object (e.g. the door roll) with the cable clip supplied.

13. Pull the door up and down to make sure it runs freely - make sure the ring gear is still disengaged.

Step 5: PROGRAM THE OPENER

The opener needs to have the dipswitches, force settings, door travel limits and remote control transmitter codes

programmed before it is fully operational. The following method of programming is recommended. Remove the 2

screws retaining the light cover, the light cover can hang on the disengagement handle. (the screws are captive and

should remain in the light cover).

Step 6: Setting DipSwitches.

There are 4 dipswitches located at the base of the opener that need to be set before power is turned on,

as follows:

B&D Australia

54321

AS3350