Instruction manual

ManualsBrandsControll-A-Door ManualsGarage Door OpenerS series

All remote control transmitter codes are learned using one of the following procedures:

Procedure 1:

• Ensure the Power LED is ON.

• Press and hold the remote control transmitter button to be

programmed. For an entry keypad the desired code should

be typed (a minimum of four numbers or letters) and the

ENTER button held down.

• Press and release the Code Set button.

• The Code Set LED will start ﬂashing to indicate that the code

has been learnt, but the door will not move.

• Release the button on the remote control transmitter.

Procedure 2:

• Ensure the Power LED is ON.

• Press the Code Set button on the opener, the Code Set LED will illuminate.

• Press and hold the remote control transmitter button to be programmed. For an entry keypad the desired code

should be typed (a minimum of four numbers or letters) and the ENTER button held down.

• The Code Set LED will start ﬂashing to indicate that the code has been learnt, but the door will not move.

• Release the button on the remote control transmitter.

Note:

1. If you release the remote control transmitter button before the CODE SET LED ﬂashes, the opener has not

learned the code.

2. Additional remote control transmitters can be programmed by repeating the above steps.

Step 9: SETTING REMOTE CONTROL TRANSMITTER

DIPSWITCH CODES.

Some remote control transmitters have a dip-switch facility.

Generally, dipswitches are used when several persons are

operating the same opener. The dip-switches must be set

to matching positions in all remotes used to activate the

opener.

• Remove the battery cover.

• Set switches in all remote controls to matching positions

(+, -, 0). Use a pen or screwdriver.

• Replace covers and program this code, using the methods

in procedure 1 or 2.

Install any ﬁxed control (eg keypad, key switch or wall button) within sight

of the door but away from moving parts and at a height of at least 1.5 metres.

Step 10: TO ERASE PROGRAMMED CODES.

If the Code Set button is pressed and held on for 6 seconds, the LED will blink rapidly for one second to indicate that

all programmed codes have been erased.

Step 11: SAFETY SYSTEM.

It is extremely important that the safety system is set up

correctly and that the system be tested/adjusted on a regular

basis. The force should be sufﬁcient to move the door during

normal operation but not excessively high to prevent the safety

system activating in the case of a collision. The opening and

closing force adjustments are the same for left-hand and right-

hand installation. The system should be set up as follows:

B&D Australia

Controll-A-Door

™

AUTOMATIC GARAGE DOOR OPENER

POWER

CODE SET

LIMIT SET

WARNING: Cover not to be removed except by

authorised technician

Code

Set

LED

Code Set Button

AS3350