Instruction manual

54321
©Copyright 2001
B&D Australia
Page 17
Changing the Light Globe
Your opener uses a 240 Volt, 25 Watt, standard bayonet Pilot Light globe. If you should need to change a light globe,
proceed as follows:
1. Close the garage door to gain better access.
2. Turn off the power at the power point.
3. Remove the light cover.
4. Remove the light globe and replace with a suitable new globe.
5. Refit the light cover.
6. Turn the power on, and
7. Press the operate button to ensure the opener is functioning correctly.
Service Call
If the opener needs service please call the dealer who installed the opener or your local B&D dealer.
Before calling for service you should have the following information to assist in providing the correct
service:
1. Has anything happened since the door was last operating OK e.g. storm, a jolt to the door etc?
2. How easy is the door to open/close?
3. What model is the opener?
4. Who installed the opener?
5. When was it installed?
6. Are there any error codes?
Maintenance
Whilst your opener does not require any periodic maintenance, the door that it is fitted to does. To ensure long and
trouble free life of your opener the following is recommended:
Monthly
• Disengage the opener and manually operate the door.
• The door must be smooth to operate by hand, and
• Operating force on the bottom rail should not exceed 200 Newtons (20kg) force.
• Each month check that the opener reverses when the door contacts a 40mm high object placed on the floor.
Adjust if necessary and recheck since an incorrect adjustment may present a hazard (AS3350). Refer to Step 12.
If the door does not operate smoothly, call B&D or your nearest B&D Authorized Dealer.
Yearly
• We suggest that you contact B&D or your nearest B&D Authorized Dealer to perform an annual door service.
Warning: Failure to maintain your garage door may void your warranty.
Frequently examine the installation, in particular cables, springs and mountings, for
signs of wear, damage or imbalance. Do not use if repair or adjustment is needed
since a fault in the installation or an incorrectly balanced door may cause injury.
AS3350
Adjustments should only be carried out by experienced persons, as this function can
be dangerous if not performed under strict safety procedures.