Instruction manual

SECTION 1 - REQUIREMENTS

IMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION

WARNING - INCORRECT INSTALLATION CAN LEAD TO SEVERE INJURY.

FOLLOW ALL INSTALLATION INSTRUCTIONS.

DOOR OPERATION

The door must be in good operating condition and the maximum effort to move the door up or down, from stationary,

should not exceed 200 Newton’s (20kg force) at the bottom rail. The door may need to be serviced to meet this

requirement - refer to door manufacturers servicing instructions

Before installing the opener, check that the door is in good mechanical condition and correctly

balanced and that it opens and closes properly. AS3350

Note: The ﬁtting of an opener to doors with removable mullions is not recommended.

POSITION

It is recommended that the opener be installed on the right hand side of the door, however the opener can be

installed on either the right hand or left hand side of the door (viewed from inside the garage looking out - left is left).

The opener must be mounted in a dry position that is protected from the weather. The B&D Controll-A-Door 5

is not

designed for external use. Moisture or corrosion may damage the opener and this is not covered by the Warranty. Do

not allow water, or other liquids, to enter the opener or remote control transmitter.

POWER SUPPLY

A properly earthed, 3 pin, 240 volt power supply is required.

WARNING! A portable power generator is not recommended. The opener may appear

to malfunction due to spikes, surges and ﬂuctuations in the generated voltage.

SIDEROOM

Dimension A = 75mm maximum. This is the distance from the door drum to the

edge of the door curtain/door guide. If dimension A is greater than 75mm, a ring gear

adaptor (Part No 59585) will be required.

Dimension B = 120mm minimum to 135mm maximum. This is the distance from

the door drum to the inside of the door bracket.

Dimension C = 165mm minimum. This is the distance from the door drum to the

garage wall.

Note:

1 The door bracket may have to be relocated to line up with the slots in the mounting bracket of the opener (the

opener may be mounted onto the axle - see Fit The Opener for special instructions.

2 The chassis must not

be cut down to reduce sideroom - the warranty is invalidated if this occurs.

3 These dimensions assume the opener will be ﬁtted while the door is on the ﬂoor. If the door is already installed an

additional 150mm clearance is required to slide the opener over the axle.

B&D Australia

AS3350