Instruction manual

Fig. 31

Fig. 32

Fig. 33

Coding Transmitters

Step 16.5 - Setting the Transmitter to Operate Pet

(Pedestrian) Mode

The opener can be programmed into a “Pet Mode” where the

door opens partially to allow pets to enter/exit the garage:

Press the DOOR CODE button ﬁ ve times, the DOOR

CODE LED will illuminate and the courtesy light will ﬂ ash

quickly (twice per second) to indicate learning mode for

Pet Mode is active.

Choose a transmitter button not already coded into the

receiver. Press this button and the DOOR CODE LED

will begin to ﬂ ash.

Press the same transmitter button again. The DOOR

CODE LED will illuminate for one second and then go

out, and the courtesy light will also switch off. This

indicates the code has been stored. This indicates the

code has been stored (Fig. 31).

The opening height of the door for pet position can only

be changed with universal programmer.

Step 16.6 - To Erase Programmed Codes

If the DOOR CODE button is pressed and held for 6 seconds

the DOOR CODE LED will blink rapidly for one second to

indicate that all programmed codes have been erased. (Fig.

32)

Step 16.7 - Installation of the Wall Mounted

Transmitter

Mount the transmitter in a convenient location, yet out

of reach of children and at least 1.5m off the ground

(Fig. 33).

Make sure the door is visible from this location.

To set the transmitter codes refer to Step 16.1.

Controll-A-Door

Instruction Manual18