Instruction manual

ManualsBrandsControll-A-Door ManualsGarage Door OpenerS series

RED

BLACK

RED

BLACK

RED

BLACK

YELLOW

R1=2.2K OHM

RED,RED,RED,GOLD

.25WATT 5% TOLERENCE

RESISTANCE

YELLOW

BLACK

V- IN V+

P.E BEAM

IMPORTANT NOTE - The Safety Infra-red

Beam must be installed and connected before

the travel limits are set - See Step 12.

WARNING: Doors requiring over 400N of force

to move must have Saftey Infra-red Beams ﬁ tted

for safety.

Step 18 - Safety Infra-red Beam

Safety Infra-red Beam extends across the door opening. This

Safety Infra-red Beam is designed to detect an obstruction

while the door is closing and to send a signal to the door

opener to reverse or stop the door movement.

Step 18.1 - Fitting Safety Infra-red Beam

Attach the mounting bracket (4) to adjustment bracket

(3) with the pan head screw (6) (supplied) (Fig. 36).

Attach the PE 2000TS bracket (2) to Safety Infra-

red Beam transmitter (IR-200TS-TX) with four taptite

screws (m3x5) and attach the other side to adjustment

bracket (3) with the pan head screw (6) (supplied).

Repeat steps a and b to assemble the Safety Infra-red

Beam ( IR-200TS-RX).

Locate the Safety Infra-red Beam in a strategic location

in the gateway. B&D recommend that the sensor is

placed 150 mm above the ﬂ oor level. Connect as per

the wiring diagram (Fig. 38).

Use 2.2 kilo ohm resistor with the colour code red, red,

red and gold on the Safety Infra-red Beams receiver

between the V- and NC terminals as shown in (Fig.

38).

Step 18.2 - Alignment

Power up the Safety Infra-red Beam. The green LED on

the transmitter and red LED on the receiver should turn

ON to indicate power is present.

If the receiver is connected to power and the red LED

is on while the green LED is on, the transmitter and

receiver are not aligned.

Make horizontal and/or vertical (Fig. 37) adjustment

on the transmitter and/or receiver until the red LED

turns off on the receiver, indicating alignment.

WARNING: When using Safety Infra-red Beam,

the doorway must be clear of all obstructions

and persons at all times. The location of the

beams and manner in which it is installed

might not give safety protection at all times.

Check to make sure that the height of the

beam and type used give maximum protection

possible.

WARNING: Install the Safety Infra-red Beam

as per diagram in Fig. 38. Tampering with the

Safety Infra-red Beam could result in serious

personal injury and/or property damage and

will void the warranty.

Fig. 36

Fig. 37

Fig. 38

Accessories

Controll-A-Door

Instruction Manual20