Instruction manual
SmartSolar™ Installation
WARNING: Do not connect batteries until
Step 20.3
Step 20.1 - Mount the Charger Board
Disconnect power to the opener.
Swing open the light diffuser and controls cover. Remove
screws marked “S” above in Fig. 40 and lift up the main
cover.
Remove the transformer and mains power cable.
Mount the PCB support with two screws .Secure the
SCG01-200 charger board on to PCB support with 3
screws. (Fig. 41).
Plug the solar charger Board’s three wire harness (red/
yellow/black) into the control board’s “SBY-3” connector
on the control board.
Plug the Charger Board’s white one wire harness into
the control board’s “24vac in” connector.
Plug the solar shunt (supplied) onto the control board’s
“JP1” solar connector.
IMPORTANT Warning: Do not connect battery
or solar panel polarity incorrectly - this will
result in serious damage to components.
Step 20.2 - Connect the Solar Panel
Mount the solar panel as outlined in the SmartSolar™
Installation Manual.
Feed the Solar Panel’s cable through black grommet
located on the top of the metal plate.
Connect the red wire to the Charger Board’s “SOLAR+”
connector, and the black wire to the “–SOLAR”
connector (Fig. 42).
Warning: During Step 20.3 the opener will
become active.
Step 20.3 - Mount & Connect the Battery
Mount the Battery Box close to the opener.
Feed the 2-core 18awg gauge cable (supplied) through
the Battery Box’s grommet.
Connect the red wire to the Battery Box’s “+” terminal,
and the black wire to the “–” terminal (Fig. 43).
Feed the other end of the battery cable through the Drive
unit’s black grommet located on the metal plate.
Connect the red wire to the Charger Board’s “BAT+”
connector, and the black wire to the “–BAT” connector
(Fig. 42).
Refi t the light diffuser and main cover.
Step 20.4 - Re-setup and Test the Opener
Setup travel limits and code transmitters.
Press either the OPERATE button or use a transmitter to
operate the opener.
a.
b.
c.
d.
e.
f.
g.
a.
b.
c.
a.
b.
c.
d.
e.
f.
a.
b.
B
l
a
c
k
(
F
r
o
m
B
a
t
t
e
r
y
)
R
e
d
(
F
r
o
m
B
a
t
t
e
r
y
)
R
e
d
W
h
i
t
e
Y
e
l
l
o
w
B
l
a
c
k
B
l
a
c
k
(
F
r
o
m
S
o
l
a
r
P
a
n
e
l
)
R
e
d
(
F
r
o
m
So
l
a
r
P
a
n
e
l
)
Re
d
Wi
r
e
B
l
ack Wire
S
S
Accessories
Fig. 40
Fig. 41
Fig. 42
Fig. 43
Controll-A-Door
®
S
Instruction Manual22