Instruction manual

Parameters

Door status indicators

Door opener state OPEN LED (green) CLOSE LED (red) Beeper

Open On

Close On

Opening Flashing

Closing Flashing

Door travel stopped Flashing Flashing

Door obstructed when opening Flashing

Door obstructed when closing Flashing Beeps while door is

moving

Opener overloaded Alternating ﬂ ashes Alternating ﬂ ashes

Mains power interrupted Rapid ﬂ ashes

Button Function

OPERATE Opens/stops/closes the door

DOOR CODE Codes a transmitter button for operate function

FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting

FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting

FORCE MARGIN SET (then) SET Reloads the factory set default obstruction force margin setting

(-) (for 6 seconds) Clears the door limits set positions. Limits then need to be reset

SET (the power on) and hold until all

LEDs are off

Deletes control parameters excluding transmitter storage memory

DOOR CODE press and hold until

DOOR CODE LED starts ﬂ ashing

Deletes all transmitter storage memory

SET & DOOR CODE (the power on)

and hold until all LEDs are off

Deletes all control parameters and transmitter storage memory

Controll-A-Door

Instruction Manual28