User's Manual

InfoProx Entry Diagnostic Routine
Displaying Diagnostic Screens
The following sequence provides a read-only view of screens that provide
information about the current InfoProx Entry unit setup and configuration.
Enter Ù to start the automatic diagnostic routine, as above,
and to move through the following diagnostic screens. Each
screen in the sequence will be titled Current Setup or
Diagnostic Tests. Once the routine is started, it can only be
stopped by shutting off the unit’s power. When the routine is
finished, it returns the user to the Administration menu.
To display diagnostic screens
n Relay idle state:
Current Setup
RO N/C
On this screen, the relay is configured as N/C (normally closed), opening
when a valid transaction is initiated (i.e., presenting a valid card).
n Keypad is enabled. If keypad entry is setup, this screen will appear:
Current Setup
Keypad.
n Door is controlled:
Current Setup
Door Reader
On this screen, the reader is configured to control a
door. By default for a door reader, input 0 monitors
door position and input 1 monitors lock position. Input
2 is for an egress button, while input 3 is unassigned.
n Indicates whether the reader has a slave device (exit reader unit)
attached and/or is connected to a DIU (Door Interface Unit):
Current Setup
SLAVE N DIU N
n Number of cards currently in the database:
Diagnostic Tests
Cd37 Fr57304
In this example, there are 37 cards in the database and room for 57304
more. The total capacity of the database is 57341 cards. Numbers are
displayed in decimal format.
Software House 57