User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
23
Chapter 2
Mounting the Terminal
You can mount the S700 terminal on the following standard electrical back boxes:
• UK single back box
• US single back box
• 75mm VESA mount
2.1 Preparing for mounting
Take care with the internal components when you are disassembling the terminal.
2.1.1 Recommended tools
The recommended tools for mounting the terminal are as follows:
• 2.5 mm flat-head screwdriver for input and output connections
• 3 mm flat-head screwdriver for DC power connections
• Wire cutters and strippers
• Security hex screwdriver - size H20
• Pozi-head screwdriver - size PZ1
Product CEM Product Code
Security screw driver handle HTO/000/001
Security screw driver bit HTO/000/000
Table 5: Security screwdriver product codes