User's Manual
Table Of Contents
- Introduction
- Mounting the Terminal
- Wiring the Terminal
- 3.1 Cabling requirements
- 3.2 The front board
- 3.3 The input/output board
- 3.4 Wiring locks
- 3.5 Terminal with Request to Exit switch
- 3.6 Configuration information
- 3.7 Terminal with third-party OSDPv2 read head
- 3.8 Terminal with third-party Wiegand read head
- 3.9 Terminal with DIU 230 and third-party Wiegand read head
- 3.10 Configuration information
- 3.11 S700e with S700s exit reader
- 3.12 S700 with DIU 210 and S700s exit reader
- 3.13 S700 terminal with DIU 230
- 3.14 Tamper detection on reader inputs
- Reader Network Configuration
- AC2000 Software Configuration
- The System Configuration Menu
- S700 Operational Modes
- Appendix 1 Updating Firmware
- Appendix 2 Broadcast and Timezone Priorities
- Appendix 3 Loading card definitions
S700-IM-0088-1.72
CHAPTER 3 : Wiring the Terminal
34
3.4.3 Inputs not in use
Some inputs must be linked out when not in use, to allow the door control to operate and
prevent alarms being generated on the AC2000 system.
This is particularly important for DIU inputs.
These inputs are outlined in the following list:
• Input 0 - door position sensor on terminal I/O board
• Fire input on a DIU
• Tamper input on a DIU
• Break Glass input on a Door Interface Unit